Customised Completely Metal - Clad and Enclosed 12kv Switchgear For
Rated Insulation Level
Lightning impulse withstand voltage
I min power frequency withstand voltage
Main Busbar Rated Current
630 - 4000
Branch Busbar Rated Current
630 - 4000
Rated Short-time Withstand Current(4s)
20, 25, 31.5, 40
Rated Peak Withstand Current
50, 63, 80, 100
enclosure IP4X, door is open IP2X
12kV Switchgear KYN28A-12
KYN28A-12 air-insulated metal-clad enclosed switchgear is a
necessary power distribution
equipment in 7.2~12kV 3-phase AC50/60Hz single busbar sectional
It is major used in power generator, substation,
factory and high building to receive and distribute electrical
power. Also it is used to control,
protect and monitor the circuit. The switchgear accords with the
standard of GB3906, DL/T404 and so on.
● Completely metal-clad and enclosed, prevent the accident
The low voltage section and the high voltage section are full
● The protection degree with the door closed is up to IP4X.
It prevents persons and outside solid approaching the live part and
ensuing persons safe and the switchgear operated reliably.
● Install and maintain conveniently with the cable compartment
● The interlocks are simple and reliable and prevent maroperation
● Equipped with advanced relay-protecting device and can realize
the power system automatically.
● Full assembled structure, handsome figure and high precision
● The switchgear installed against wall is maintained in the front;
double-side maintenance is convenient and reliable.
● There are pressure relief passages in the trolley compartment,
busbar compartment and cable compartment.
Thus ensure persons safely and prevent accident spreading when
electrical arc occurs due to fault
■ Normal use condition
● Ambient air temperature:maximum temperature+40 ℃, minimum
● Humidity condition:daily average relative humidity: ≤95, daily
average vapor pressure shall not exceed 2.2Kpa;
Monthly average relative humidity: ≤90?, Monthly average vapor
pressure shall not exceed 1.8Kpa
● Altitude:Below 3000m.
● Earthquake intensity:Lower than 8 degrees.
● The ambient ait shall not be polluted by distinctive corrosive ot
conbustble gas, vaporetc.
● Places free of frequent excessive vibrations.
● The user shall negotiate with manufacturer if the equipment is
used beyond the normal conditions described in GB3906.
■ Design featuers
● Switch gear structure plesse see to figurel.
● Entirely metal armored, assembly structure, wide range of
● The cabinet body adopts importes aluminized and galvanized sheet
, which is prossed
With CNC machine tool and advanced multiple flanging techniques ang
connected with excellent nuts
and bolts of high intensity, providing high precision,
anticorrosion, Small weight, high intensity, and good parts
● Itcan assembly home produced ZN63A-12 series or the imported VD4
series vacuum circuit breakers,
with wide applicability, high reliability, free og maintenance for
Mainrenance for long years.
● Operation and testing positions will be established for the
handcart, and both positions are equipped with safe
and reliable positioning device and display device.
● All kinds of hancars shall change in a modulus cordwood manner,
so as to insure that handcares of same kind can be freely
while carts of different kinds are stirictly stopped from entering.